Hour 65 - Right Triangle
- Details
- Category: Quickheads BLOG
- Published: Wednesday, 21 October 2009 01:00
- Written by Dan Yager
- Hits: 4232
{flv}construction/hour065{/flv}
In this video the flox is cured on the right side longeron, so I removed all of the clamps. The LAST-A only comes in sheets that are 24" wide and this wasn't quite wide enough to fill the area that needed to be filled where the header tank belongs. Therefore, towards the forward edge of the longeron there was a small triangular piece of LAST-A foam missing.
So I simply cut out a small piece of foam, mixed up some micro slurry and clamped it into position. I'll do the final trimming of the foam when it's all cured.
I'll do the same thing on the other side in the next video. . . So stay tuned! 
As always I invite your feedback below, or in the forums!