Q2 Plans Chapter 20 Page 20-02
- Details
- Category: Q-2/Q-200 Plans
- Published: Monday, 01 May 2006 20:05
- Written by Quickie Aircraft Corporation
- Hits: 3696
CANARD/FUSELAGE FAIRING
..... At this point, their should be a noticeable and ugly gap under the fuselage where the canard and fuse¬lage meet. A fairing should be made out of scrap foam and 1 BID similar to the picture. MAIN WING TIPS
..... Now would also be a good time to carve wing tips on the main wing. If you wish, you may add up to 3 inches of foam to the wing span to facilitate a smooth looking wingtip. Keep it simple, however. VERTICAL FIN TIP
..... Ditto for the tip of the vertical fin. VERTICAL FIN ATTACHMENT
..... Previously, you mounted the vertical fin to the bottom of the fuselage. Now is the time to permanently attach it to the fuselage and create a pleasing fillet shape at the same time. Using pieces of foam, fill the gap between the vertical fin and the aft fuselage. Carve the foam down to a pleasing shape, as shown, and laminate 2 BID overlapping onto the aft fuselage skin a minimum of 2 inches. |
||||
|
||||
PAGE
20-2 |