Q1 Plans Chapter 11 Page 11-8
- Details
- Category: Quickie Plans
- Published: Wednesday, 03 September 2008 01:00
- Written by Dan Yager
- Hits: 2020
The brake pull handle is carved out of pine, or any other durable wood. The 1/16” cable is looped through a hole in each end of the handle and then is connected with two nicropress sleeves to the 1/16” brake cable that runs continuously from the left pant to the right pant. Remember to thread the two nicropress sleeves for the brake handle cable before hooking up the two BSW1’s.
The brake pull handle is positioned conveniently on top of the fuel tank with Velcro tape.
After installation, check that the brakes do not drag against the tire in the “off” position.
Also, brake efficiency will be poor until the shoes and tires have worn in somewhat.
CONTINUED ON NEXT SHEET