Q1 Plans Chapter 9 Page 9-1

Details

Category: Quickie Plans

Published: Wednesday, 01 October 2008 01:00

Written by Dan Yager

Hits: 2923

BUILDING THE MAIN WING

The main wing is a composite structure with solid foam core, spanwise tapes of UNI for bending strength, and two layers of UNI St 45 deg. to the trailing edge for torsional Stiffness and Surface durability The trailing edge of the wing is perpendicular to BLOO, i.e. the trailing edge of the wing has no Sweep. The ailerons are attached to the inboard half of the wing, and there is a shear web in the inboard half of the wing also.

First, you should cut out the UNI spar caps. Letter each One of them for identifying later, as well as Placing a centerlje in the middle(where the LINI will cross BLOO). For Cutting the spar caps out, use the technique described in the basic education section

CONTINUED ON NEXT PAGE